![background image](http://html.mh-extra.com/html/viking-range/5-series/5-series_manual_1026175006.webp)
6
I NSTALLING THE ANTI TIP DEVICE FOR FREESTANDING INSTALLATIONS
!
CAUTION
NOTE
Bottom View of
Refrigerator
Anti-Tip
Bracket
Leveling Leg
Front of cabinet
21
1
⁄
2
"
(54.6 cm)
Figure 7
Floor Mount Installation
The anti-tip bracket is to be located on the
fl
oor in the left or
right rear corner of the refrigerator as shown in Figure 7.
Step by step instructions for locating the
position of the bracket:
1) Decide where you want to place the refrigerator. Slide it
into place, being careful not to damage the
fl
oor, leaving 1"
(2.5 cm) of clearance from the rear wall to allow room for
the anti-tip bracket.
2) Raise the rear leveling legs approximately
1
⁄
4
" (6 mm)
to allow engagement with the anti-tip bracket. Level the
unit by adjusting all the leveling legs as required. Turning
the leveling leg counterclockwise will raise the unit and
clockwise will lower the unit.
3) Make sure the refrigerator is in the desired location, then
mark on the
fl
oor the rear and side corner of the cabinet
where the anti-tip bracket will be installed. If the installation
does not allow marking the rear corner of the cabinet, then
make temporary lines on the
fl
oor marking the front corner
of the cabinet, excluding the door. Slide the refrigerator out
of the way. From the temporary line extend the sidewall line
back 21
1
⁄
2
" (54.6 cm) as shown in Figure 8.
4) Align the anti-tip bracket to the marks on the
fl
oor so
the side of the bracket lines up with the side of the cabinet
mark, and the "V" notches on the anti-tip bracket line up
with the end of the 21
1
⁄
2
" (54.6 cm) line (Rear of cabinet
line).
5) Fasten the anti-tip bracket to the
fl
oor using the supplied
screw. (See Figure 8).
6) Slide the cabinet back into position, making sure the
rear cabinet leveling leg slides under the anti-tip bracket
engaging the slot.
!
WARNING
• ALL
APPLIANCES
CAN
TIP
RESULTING IN INJURY.
• INSTALL
THE
ANTI-TIP
BRACKET PACKED WITH
THE APPLIANCE.
• FOLLOW
THE
INSTRUCTIONS BELOW
Any
fi
nished
fl
ooring should be protected with appropriate
material to avoid damage when moving the unit.
If installing on a concrete
fl
oor, concrete fasteners are
required, (not included with the anti-tip kit).
Anti-Tip Device
!
WARNING
If your refrigerator is not located under a counter
top (free standing), you must use an anti-tip device
installed as per these instructions. If the refrigerator is
removed from its location for any reason, make sure
that the device is properly engaged with the anti-tip
bracket when you push the refrigerator back into the
original location. If the device is not properly engaged,
there is a risk of the refrigerator tipping over, with the
potential for property damage or personal injury.