INSTALLATION STEPS
*NOTE: Prior to any installation, mark
lines on the floor and wall for proper
dry fit. Proper planning is imperative
for proper installation. The
measurements of 70 7/16" or 62 3/8"
should just be used as a guide. Your
actual dimensions may vary.
MODEL VG06041
6
A1
DOOR PANEL
(#5) INSIDE OF
THE SHOWER
A2
1
1
62 3/8" or 70 7/16"
The dimension supplied
is measured at the center
of the wall mount bracket.
There is a 13mm adjustment
built into the bracket.
13mm
1
A.
INSTALLING THE STRUCTURAL RAIL
1.
Place the door panel (#5) into the shower
first making sure to rest the glass in a
manner that the glass or base/tub does not
incur damage.
2.
Place the structural rail into the cabin
opening. Make sure that the wall mount
brackets (#1) are assembled on the rail
before doing this. If the rail is too long, cut
it 5/8" - 3/4" shorter than the cabin opening
with a hacksaw to fit properly in the
opening.
Make sure to cut the rail on the
shower door side only.
Arrange the glass
according to the configuration you've
chosen from page 4. Measure *70 7/16" for
all shower doors or 62 3/8" for tub doors
from the floor or curb of base. Mark this
location. This will be the height of your wall
mount bracket assembly (#1).
!