3
Your new faucet is designed for years of trouble-free performance.
Keep it looking new by cleaning it periodically with a soft cloth. Avoid abrasive
cleaners, steel wool and harsh chemicals as these will scratch, dull, and/or
damage the finish and/or product void your warranty.
Adjustable wrench
Groove joint pliers
Plumber's putty
Pipe tape
Phillips and flat screwdrivers
Be sure to shut off water supply prior to installation.
Protect your eyes with safety glasses when cutting or soldering water supply lines
Cover your drain to avoid losing parts.
Prior to beginning installation, turn off the cold and hot water lines and open the
hot and cold knobs on the old faucet to release build-up pressure.
When installing your new faucet, turn the connector nuts finger-tight, then use one
wrench to anchor the fitting and a second wrench to tighten the nut one additional
turn. Connections that are too tight will reduce the integrity of the system.
Wrap all threaded connections with Teflon tape available at your
local hardware or plumbing supply store. Always wrap in a clockwise direction.
All installations can vary depending on how your previous faucet was installed.
Not all necessary supplies to install your faucet are included, however, they are
available wherever plumbing supplies are sold.
Installation must be done by a qualified licensed plumber.
Prior to installation please read the instructions thoroughly, confirm that all parts
are included and visually inspect the unit for any defects.
If you have any questions please contact the Vigo Technical Support
Department before proceeding with installation.
MAINTENANCE
REQUIRED TOOLS
IMPORTANT POINTS
SAFETY TIPS
INSTALLATION
ASSEMBLY
PACKAGE CONTENTS
5. PLACE NEW FAUCET IN THE
POSITION ON THE SINK. PLACE
BASE RING BETWEEN BOTTOM OF
THE FAUCET AND SINK SURFACE.
FROM UNDER THE SINK, PUT
RUBBER WASHER AND BRASS
RING AND THREAD NUT ONTO THE
PIN. TIGHTEN NUT.
6. CONNECT FEMALE END
OF FLEXIBLE HOSES TO THE
COLD AND HOT WATER
SUPPLY.
TWO
FLEXIBLE
HOSE
1 SHUT OFF WATER
SUPPLY. REMOVE OLD
FAUCET AND FLEXIBLE
HOSES. CLEAN SINK
SURFACE IN PREPARATION
FOR NEW FAUCET. FLUSH
WATER CONNECTION AT
HOME TO MAKE SURE NO
DEBRIS IS STUCK IN THE
LINE.
2. SCREW MALE END OF
FLEXIBLE HOSE TO THE
FAUCET
3. INSTALL PIN TO THE
FAUCET
4. SLIDE THE BASE
RING ONTO THE
PIN AT THE
BOTTOM OF THE
FAUCET.
RUBBER
RING
FAUCET
1
5
2
4
3
BASE
RING
6
7. AFTER INSTALLATION IS COMPLETE, REMOVE THE AERATOR.
TURN ON THE WATER SUPPLY VALVES AND ALLOW BOTH HOT AND
COLD WATER TO RUN AT LEAST ONE MINUTE EACH. WHILE WATER IS
RUNNING, CHECK FOR LEAKS, ESPECIALLY AT HOOK-UPS TO
SUPPLY LINES. TIGHTENING NUTS SLIGHTLY WILL STOP ANY MINOR
LEAKS.
BASE RING
PIN
BRASS RING
RUBBER WASHER
NUT
