Viglen BX130 – VIG385P User Manual
23
Table 1:
Jumper Settings
JPUSB1 & JP USB2:
USB Wake-Up
Use JPUSB jumpers to enable the function of "System Wake-Up via
USB devices", which allows you to "wakeup" the system by depressing
a key on the USB keyboard or by clicking the USB mouse of your
system. The JPUSB jumpers are used together with the USB Wake-Up
function in the BIOS. Enable both the jumpers and the BIOS setting to
allow the system to "wake-up via USB Devices". (*Note: JPUSB1 is for
Back Panel USB ports:1/2/3/4/5/6, and JPUSB2 is for Front Panel USB
ports:7/8.)
(*Note: The default jumper setting for the USB ports is "Disabled".
However, when the "USB Wake-Up" function is enabled in the BIOS
and the desired USB ports are enabled via the JPUSB jumper, please
be sure to remove all USB devices from the USB ports whose USB
jumpers are set to "Disabled" before the system goes into the standby
mode.)
JP5:
Watch Dog
JP5 enables the Watch Dog function. Watch Dog is a system monitor
that can reboot the system when a software application is "hung up".
Pins 1-2 will cause WD to reset the system if an application is "hung
up". Pins 2-3 will generate a non-maskable interrupt signal for the
application that is "hung up".
JFSB1 & JFSB2
CPU FSB speed
JFSB1 and JFSB2 allow you to set the Front Side Bus Frequency.
(*Default is Auto.)
CAUTION!
Do not move the jumper with the power on. Always turn off the power and unplug the power
cord from the computer before changing the jumper.
Summary of Contents for BX130
Page 8: ...Viglen BX130 VIG385P User Manual 7 Figure 2 Chassis Overview ...
Page 23: ...Viglen BX130 VIG385P User Manual 22 Jumper Settings Figure 6 Jumper Settings ...
Page 28: ...Viglen BX130 VIG385P User Manual 27 ...
Page 29: ...Viglen BX130 VIG385P User Manual 28 ...