Vigilant
MX1-Au
Operator Manual
Document: LT0439
Page
23 October 2018
Issue 1.73
3-6
From the Disables List other options are available by pressing the
MENU
key. These are described in the next section.
There are commands available from the Disable menu to disable or
enable whole blocks of zones or points as well as individual zones or
points.
Press the
DISABLE
key from the base display. Alternatively, from the
Disables List, press the
MENU
F4
option. This gives a menu of what to
disable or enable.
Do not press the f.b.p
DISABLE
key when the Alarm List is
being shown unless the intent is to disable all alarms.
Select item to disable or | ZONE
enable | POINT
|ALRM DEV
| ANCILS
Fig 3-5 – Selecting an Item to be Disabled or Enabled
ZONE
F1
allows a zone or range of zones to be enabled/disabled.
Refer to Disabling or Enabling a Zone (page 6-9).
POINT
F2
allows a point or range of points to be enabled/disabled.
Refer to Disabling or Enabling a range of Points (page 6-7).
ALRM DEV
F3
allows the Alarm Devices to be enabled/disabled.
ANCILS
F4
allows the ancillary groups to be enabled/disabled (see
page 3-7).
From the Disable Menu press
ALRM DEV
F3
to enable/disable the
alarm devices. The confirmation screen will show the action that is about
to be performed (i.e., enable or disable) and request the
OK
key be
pressed.
If
OK
is pressed the action is carried out, otherwise press CANCEL to
return to the previous screen.
Disable Menu Options
Alarm
Devices
