Tools Required for Assembly:
Cordless Drill
3/8” Brad Point Drill Bit
Hot Glue Gun or Double Stick Tape
Phillips Screw Tip w/ Extension
Wire
Strippers
Electrical Tape
Wire Nuts (optional)
Parts List:
(1) Vigilant accent lighting kit
(9) Mahogany replacement slats
(18) Slat screws
Step 1
Step 1 - Removing
Identify the slats you need to remove (see Diagram 6 or 7), and carefully remove by pulling off with pliers.
Remember, you will need to drill an escape hole, (step 6) in your arch top, for the wire to come out.
Step 2
Step 2 - Lighting Kit
Follow the lighting kit instructions to begin setting up your lighting kit for use in your arch top. You will need to
leave extra wire off of the end of the valance to thread through the drilled escape hole.
Step 3
Step 3 - Positioning
the Valance
Starting at the right side of the arch top opening, bend the valance and slide it
underneath the slats. Position it flush to the underside of the arch top roof (see Diagram 6 or 7
on page 9
).
Step 4
Step 4 - Attaching
the Valence
Using your drill and screw gun, attach the valance to the arch top roof above the three openings with the supplied
screws from your lighting kit.
Step 5
Step 5 - Drill your Escap
e
Drill your wire escape hole through the roof or side of the arch top and thread the extra wire from the valance
through from Step 2.
For additional installation assistance on steps 6 through 8, refer to the installation instructions for the
LED
lighting kit.
Step 6 - Attaching Bulb Holders and Bulbs
Attach your bulb holders and your bulbs to the valance at each of the three slat openings in the arch top.
Pre-Installed Lighting
The valance wire will need to be connected to the transformer wire.
Step 1:
Pull the valance wire
through the back or top hole of
the arch. (Note: It is important to review your elevation drawing to help
determine which hole should be used so that it does not
interfere with the assembly of your wine
room.)
Step 2:
Take the stripped end of the valance wire and split it in half to create two
ends to
connect to the bridge.
Step 3:
Loosen the holding screw on the bridge that is attached to the
transformer wire. Run the
valance wire into the open connection points and re-tighten the holding
screw until it is secure. The arch is now connected to the
transformer and ready for final installation
into your wine room.
Note: Below are the steps Vigilant took to pre-install the display lighting in your slatted arch.
Please use these steps if
you need to replace a bulb or bulb holder. Replacing a bulb in your
beadboard disk lighting is as simple as removing the diffuser trim, removing the bulb, and
replacing it with a new glass
wedge bulb.
Arch Top Lighting Installation - (If Applicable)
8
