Operation
40
4.
Press to select the item you want to modify and press
MODE/ENTER
on the
projector or
ENTER
on the remote control.
5.
Press / to move the cursor and the press
/ to enter the value.
6.
To save the settings, press
MODE/ENTER
on the projector or
ENTER
on the remote
control. If you do not want to save the settings, press
MENU/EXIT
on the projector
or
Exit
on the remote control.
7.
Press
to
highlight
Apply
and press
MODE/ENTER
on the projector or
ENTER
on the remote control.
•
If the RJ45 cables are not properly connected, the IP Address, Subnet Mask, Default
Gateway, and DNS settings will display 0.0.0.0. Make sure the cables are properly
connected and perform the procedures above again.
•
If you wish to connect to the projector in its standby mode, be sure you have selected
RJ45 and obtained the IP Address, Subnet Mask, Default Gateway, and DNS information
when the projector is on.
Wireless LAN connection
To connect to the projector wirelessly, you have to plug a ViewSonic wireless dongle
(optional) to the USB Type A connector on the projector, and then only a few OSD
configuration steps are required.
1.
Make sure the projector is turned on.
2.
Press
MENU/EXIT
on the projector or
Menu
on the remote control and then press
/ until the
SYSTEM SETUP: Basic
menu is highlighted.
3.
Press
to
highlight
LAN Control Settings
and press
MODE/ENTER
on the
projector or
ENTER
on the remote control. The
LAN Control Settings
page is
displayed.
4.
Highlight
Wireless LAN Status
and press
MODE/ENTER
on the projector or
ENTER
on the remote control.
5.
Check the information displayed on the menu.
You can change the wireless settings on the Network Control > Administrator Login >
Network Setup page. To access the page, see page
42
for details.
About AP and Infrastructure modes
In
AP
mode, you need to use your computer’s wireless connection utility to search for the
projector’s SSID and connect to it. Then you can search for the projector with vsPresenter.
In
Infrastructure
mode, you should connect both your computer and projector to the same
AP router and make connections with the IP address.
The following diagram describes how to access the Internet in
AP
and
Infrastructure
modes.
Internet
Internet
(AP mode)
(Infrastructure mode)
Downloaded From projector-manual.com Viewsonic Manuals
