26
Fine-tuning the image clarity
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either the
top or bottom. It occurs when the projector is not perpendicular to the screen.
To correct this, besides adjusting the height of the projector, you will need to manually
correct it following one of these steps.
•
Using the remote control
Press
/
to display the Keystone correction
page. Press
to correct keystoning at the top of
the image. Press
to correct keystoning at the
bottom of the image.
•
Using the OSD menu
1.
Open the OSD menu and go to the
DISPLAY >
Keystone
menu.
2.
Press
Enter
. The
Keystone
correction page is displayed.
3.
Press
to correct keystoning at the top of the image or press
to correct
keystoning at the bottom of the image.
Magnifying and searching for details
If you need to find the details on the projected picture, magnify the picture. Use the
direction arrow keys for navigating the picture.
•
Using the remote control
1.
Press
on the remote control to display the Zoom bar.
2.
Press
repeatedly to magnify the picture to a desired size.
3.
To navigate the picture, press
Enter
to switch to the paning mode and press the
directional arrows (
,
,
,
) to navigate the picture.
4.
To reduce size of the picture, press
Enter
to switch back to the zoom in/out
functionality, and press
repeatedly until it is restored to the original size. You can
also press
Auto Sync
on the remote control to restore the picture to its original size.
•
Using the OSD menu
1.
Open the OSD menu and go to the
DISPLAY >
Zoom
menu.
2.
Press
Enter
. The Zoom bar is displayed.
3.
Repeat steps 2-4 in the section of Using the remote control above.
This function is only available when a PC input signal is selected.
The picture can only be navigated after it is magnified. You can further magnify the picture
while searching for details.
If necessary, sharpen the image by rotating the focus ring.
Press
/
Press
/
Summary of Contents for PJD5353LS
Page 84: ......
