47
Using the dust filter
(optional accessory)
CAUTION
•
It is important to clean the dust filter every 100 hours after the dust filter is installed.
•
Be sure to turn off the projector and unplug it from power source before installing or
detaching the filter.
•
If your projector is ceiling-mounted or is not easily accessible, pay special attention to
your personal safety when replacing the dust filter.
Installing the dust filter
1.
Be sure to turn off the projector and unplug
it from power source.
2.
As the arrows shown to the right, fit the filter
by aligning and inserting it into the projector
slots. Make sure it clicks into place.
For first time installation:
3.
Open the OSD menu and go to the
SYSTEM SETTING: ADVANCED
>
Filter
Settings
menu
.
4.
Press
Enter
and the
Filter Settings
page is displayed.
5.
Highlight
Filter Mode
and press
/
to select
On
. The filter timer starts counting
and the projector will remind you to clean the filter when the filter is in use for over
100 hours.
Set Filter Mode to On only when using the projector after the dust filer (optional accessory) is
properly attached. Failing to do so will result in a shorter lamp life.
Obtaining the filter hour information
1.
Open the OSD menu and go to the
SYSTEM SETTING: ADVANCED
>
Filter Settings
menu
.
2.
Press
Enter
. The
Filter Settings
page is displayed.
3.
You will see the
Filter Hours
information on the menu.
Cleaning the dust filter
1.
Be sure to turn off the projector and unplug it from power source.
2.
Press the latches on the dust filter and remove the filter from the projector.
3.
Use a small vacuum cleaner or a soft brush to sweep the dust on the filter away.
4.
Re-install the dust filter.
Resetting the filter timer
5.
Open the OSD menu and go to the
SYSTEM SETTING: ADVANCED
>
Filter Settings
menu
.
6.
Press
Enter
and the
Filter Settings
page is displayed.
7.
Highlight
Reset Filter Hours
and press
Enter
. A warning message is displayed
asking if you want to reset the filter timer.
Summary of Contents for PJD5353LS
Page 84: ......
