VIEWEG
EN
Operating Manual DC 200
4 Start & Operation
• Connect the power inlet cable to the Power inlet connector on the backside.
• Connect the Air Inlet tube from the compressor to the Air Inlet at the backside of the
DC 200.
• Connect the Foot switch (optional C-0040) or the dispense cable of the dispense
robot to the foot switch connector in the backside of the DC 200.
• Switch ON the liquid dispenser. The green POWER-LED lights. The device is now
ready for work.
• Connect the cartridge to the adapter like following diagram:
• Connect the air tube of the cartridge adapter to the air pressure output of the
DC 200 and adjust the pressure fur the cartridge on the front side with the pressure
controller.
• Adjust the Vacuum to reduce material dripping.
NOTICE
The dispensing quantity depends on the set pressure,
the size of the dispensing needle, the viscosity of the
material and the dispensing time.
You will fi nd tips on dispensing in our brochure
Simply
dispensing
.
• Select MODE on the switch on the front side:
• Timer OFF:
The DC 200 dispenses as long as the foot switch is applied.
• Timer ON:
The DC 200 dispenses as long as the timer is adjusted. #
A short apply on the foot switch is enough.
17
