9
D. OPERACIONS
To start up this system and enjoy the music, please
take following steps:
1. Connect the power adapter between the
transmitter and power outlet, the LED on the
transmitter will light up in green.
2. Connect the transmitter with your audio source,
turn the source ON, the LED will turn from Green to
Blue.
3. Turn on the headphone receiver by pressing ON/
OFF switch, LED will then flash in blue.
4. If the LED on the headphone is OFF immediately,
please put the headphone back to the transmitter for
recharging.
5. When the audio link is established, LEDs turns to
Blue.
6. If the LED on the headphone still flashes in blue,
please check with troubles shooting processes.
Pairing the Headphone receiver with the
transmitter
If the LED on headphone flashes in blue and does not
work, start the Pairing process as below:
1. Press the Pair button on the transmitter and the
headphone simutaneously for 3 seconds until the
Blue LEDs flashes. The LEDs will change to solid
Blue when pairing process is finished.
Transmitter Auto Stand by and Headphone
Auto Shut off
1. The transmitter will automatically turn to stand
by mode after approximately 4 minutes if there is no
audio signal, or the signal that it receives from
the audio source is too weak for proper reception. If
however the signal returns to an acceptable level, the
transmitter will automatically switch back on.
2. The headphone receiver will automatically shut
off if there is no signal from thre transmitter after 15
minutes.
E.Charging the batteries
1. Switch OFF the receiver headphone.
2. To recharge the headphone batteries, place the
headphone on the transmitter, ensure that the
charge contacts touch the transmitter’s charge
pins. The LED on the headphone will light up in red,
when charging is finished the headphone LED will
turn green.
3. Charge the batteries in the headphone for 5
hours when use for the first time. The red indicator
light will be in solid red during battery charging.
F.Wired Headphone Application
The headphone can be applied in wired mode. Simply
connect the headphone and the audio source by the
supplied 3.5mm to 3.5mm audio cable. You will then
enjoy the audio in wired mode.
