12
Accessing/Altering the Time Program for Space Heating
The time program consists of four heating cycles. In the factory default setting,
heating cycle 1 is set for every day of the week from 06:00 to 22:00 hrs., which
means that during this time period space heating takes place according to the
selected “normal room temperature”.
The following options are available to you to set the heating cycles to your liking:
H
By selecting the corresponding heating cycle, space heating can alternate up to
four times a day between “normal room temperature” and “reduced room
temperature”.
H
You can select the same heating cycle or individual heating cycles for each day
of the week.
When setting the heating phases please pay attention to the reaction time of your
heating system. Please select beginning and end of each cycle accordingly.
Setting the same heating cycles for each day of the week
Time Prog. Heating
1---7
1
1---7
1
1. Open flip-down cover of the remote
control
1
2.
for “Time Prog. Heating”,
wait until display on the
left appears.
1
3.
for “Heating Cycle 1”
1
4.
for “Heating Cycle 1 On”.
1
5. /
for setting the start of
Cycle 1
1
6.
to confirm;
the display switches to
“Heating Cycle 1 Off“.
1
7. /
for setting the end
of Cycle 1.
1
8.
to confirm;
the display changes to
“Heating Cycle 2 On“.
1
9. For setting starting and ending
times for Cycles 2 to 4 proceed as
described in steps 5 to 8.
10. Close flip-down cover of the control
unit.
Accessing heating cycles
Proceed as described above with the
exception of pressing buttons
and
.
Overview of heating cycles
1. Open flip-down cover of the control
unit.
2. Press both
and ; the selected
cycles are shown on a time line.
3. Close cover of control unit.
If you would like to terminate the
heating cycle settings prematurely,
press
again.
If you would like to skip a heating
cycle, press .
Once the last setting is confirmed
with
the display will show the
current time.
51
67
50
5