15
Possible Problems
Changing the Address Code
Only for the Vitotrol 100, type UTDB-RF, if flashes on the wireless receiver.
1. Press on the wireless receiver for approx. 10 seconds until flashes
2. Open the flap on the Vitotrol 100
3. Press twice
4. Use to select
"Settings"
5.
Confirm with
OK
6. Use to select
"Service"
7.
Confirm 3 times with
OK
8. Use to select
"Address code"
9.
Confirm with
OK
The display shows a number combination for approx. 30 seconds. Then
"Send data"
appears on the
display. The transfer takes 30 seconds. flashes during the transfer.
If the receiver recognises the address code, and go out. If the address code is not recognised,
repeat the process from point 3.
