Vitosol 200-T, SP2A Technical Data
5782 590 - 02
8
8
Installation on Flat Roofs
Design Information
Horizontal installation on flat roofs (non-elevated)
Yield can be optimized by rotating the vacuum tubes to
25° to the horizontal plane. The collector must be sloped
greater than 0°.
Ballast and maximum load on the substructure
Calculation in accordance with DIN 1055-4, 3/2005 and
DIN 1055-5, 7/2005 or applicable local codes.
Two support slabs each, both A and B are required for
every collector.
Ballast weight requirements, as well as the calculation of
additional live loads (due to installation of solar collectors),
must be evaluated by a professional structural engineer.
A
Support slabs A
B
Support slabs B
Installation on Walls
Horizontal installation on walls
For installation on balconies, there is a special 10-tube
1.26 m
2
collector model.
Yield can be optimized by rotating the vacuum tubes
to 25° to the vertical plane. Run the hydraulic pipe
connections from below and use the air vent at the high
point of the manifold.
A
Facade or balcony
