27
Note
The control unit is adjusted so that the settings for DHW heating apply to all heating
circuits. If you want to make changes, contact your local heating contractor.
Observe the following points if you want to enable DHW heating:
You can select the required DHW temperature (see page 28).
Check whether
"Heating and DHW"
or
"Only DHW"
is set for the relevant heating
circuit.
Press the following keys:
1.
"MENU".
2.
|
/
~
for selecting
"Heating circuit
1"
(HK1),
"Heating circuit
2"
(HK2) or
"Common
circuit"
.
3.
d
to confirm.
4.
|
/
~
for
"Heating program"
; the
check mark must be next to
"Heating and DHW"
or
"Only DHW"
.
If not, proceed as follows:
5.
|
/
~
for
"Heating and DHW"
or
"only DHW"
.
6.
d
to confirm.
7.
g
press until the standard
display is shown (see
page 10).
When DHW heating is enabled for the heating circuit and when the DHW circulation
pump (if installed) runs, depends on the settings of the switching times for the
respective day (four possible time phases, see page 30).
Note
If DHW heating is set to automatic mode (see page 29) switching times are scanned
when scanning the switching times for central heating (see page 17).
Press the following keys:
1.
"MENU".
2.
|
/
~
for selecting
"Heating circuit
1"
(HK1),
"Heating circuit
2"
(HK2) or
"Common
circuit"
.
3.
d
to confirm.
Selecting DHW heating
Selecting constant DHW heating
5592 598 GB
