Vitodens 100-W B1HE/B1KE Operating
6167 819 - 01
22
Switching Internet Access On or Off
Further Adjustments
You can control your system remotely via the internet
using an app. To do this, establish an internet connection
via WiFi: See the following chapter.
The required credentials for internet access to the control
unit via app can be found on the adjacent label:
Establishing a WiFi connection
Tap the following buttons:
1. Call up the home screen.
2.
3. Press and hold OK for approx. 4 sec.
Information is displayed.
4. Follow the instructions in the app.
Fault while establishing the connection
“E10” Could not connect to local network.
Note:
If “E10” appears on the display, check the
connection to the router and whether the
network password is correct.
“E12” Connection to the server cannot be established.
Note:
If “E12” appears on the display, re-establish
the connection at a later time.
5. At the end, OK to confirm
6. OK to acknowledge the information
7.
for approx. 4 sec, to exit the menu.
Switching WiFi on and off
Tap the following buttons:
1. Call up the home screen.
2.
+ OK: Press and hold simultaneously for
approximately 4 sec.
Restoring Factory Settings
Tap the following buttons:
1. Call up the home screen.
2.
3.
for “Settings”
4. OK to confirm
5.
for “Factory settings”
6. OK to confirm
7. OK to acknowledge the information
Energy Metering Settings
You can set the values for the correction factor and
calorific value to determine consumption arithmetically.
To call up the values: See page 26.
You can reset all entries and values to their factory settings.
Settings and values that are reset with all operating modes:
Room temperature or supply temperature
Operating program
DHW temperature
Time program for DHW heating
Tap the following buttons:
1.
2.
for “Energy metering”
3. OK to confirm
4.
for “Consumption”
5. OK to confirm
6.
for “Settings”
7. OK to confirm
8.
for “Correction factor” or “Calorific value”
9. OK to confirm
10.
to enter values.
11. OK to acknowledge the information
Attach the WiFi label here
