Vitodens 200-W B2HA/B2HB, 222-F B2TA/B2TB Operating
5461 885 - 04
24
Heating
Setting the Time Program for DHW Heating
(continued)
Deleting a time phase
Set the time for the end point to the same time that was
set for the start point. The display shows the selected
time phase “- - : - -”.
DHW heating once, no longer in the time program
Note:
The heating program “Heating and DHW” or “Only
DHW” must be set for at least one system heating
circuit.
Extended menu:
1.
2. “Heating”
3. “Party
mode”
4. Disable “Party mode” again with “OFF” to prevent
unintentional central heating with standard room
temperature.
Heating system with DHW circulation pump
Further information about the DHW circulation pump
can be found under “Terminology” on page 40.
H
Automatic mode
is set for the DHW circulation pump
time program. In other words, the DHW circulation
pump operates in parallel to the DHW heating time
program.
H
If you don’t want the automatic mode, you can select
up to 4 individual time phases per day for the DHW
circulation pump, which can be the same for every day
of the week or different. Set the start and end points
for each time phase.
H
In the “Information” menu, you can scan the current
time program (see chapter “Scanning information”,
“DHW” group).
Note:
Activating the DHW circulation pump is only
advisable for those times when DHW is actually
drawn.
Extended menu:
1.
2. “DHW”
3. “DHW circ time prog”
4. “Individual”
5. Select part of the week or a day
6. Select the time phase
!
,
?
,
§
or
$
.
7. Set the start and end points for the relevant time
phase
Note:
If you want to terminate the setting process
prematurely, keep pressing
until the required
display appears.
