Vitodens 200-W B2HA/B2HB, 222-F B2TA/B2TB Operating
5461 885 - 04
10
Menu
Controls
Note:
The programming unit can be placed in a wall
mounting base. This is available as an accessory.
Ask your heating contractor for more information.
Programming unit
Takes you to the previous step in the menu or
cancels a setting that has been started
Cursor keys To scroll through the menu or to set
values
OK
Confirms your selection or saves the setting
?
Calls up help texts for the selected menu option
Calls up the extended menu
“Help” menu
You can view a short guide giving an explanation of the
controls and information about heating circuit selection
(see page 16).
Call up the short guide as follows:
H
If the screen saver is active (see page 12): Press
?
.
H
If you are somewhere in the menu: Press
until the
standard menu is shown (see the following chapter).
Press
?
.
Refer to the remote control
operating instructions
You can change any settings on your heating system
centrally at the programming unit of the control unit.
If remote controls are installed in your rooms, you can
also adjust the settings at the remote controls.
There are two control levels available, the “Standard
menu” and the “Extended menu”.
Standard menu (heating circuit only)
A
Header (shows the heating program for displayed
heating circuit
D
)
B
Current outside temperature
C
Set room temperature
D
Heating circuit which is selected for operation in the
standard menu
A
Header zone circuit which is selected for operation
in the standard menu.
B
Heating
C
Zone circuit pump output active
D
Current outdoor temperature. Only for zone circuits
with weather compensated operation.
E
In conjunction with solar thermal system:
Solar circuit pump running
F
Set zone circuit temperature
G
Burner in operation with modulation rate in %.
Standard menu (when zone circuit is set)
