3
Usage:
Fan operation:
Always operate the fan in the upright position
following all instructions and recommendations listed in this
manual.
Fan Location:
Place the fan in the area of the room that will
provide proper fan cooling. FAN CONNECTION: Plug fan directly
into 120 volt A.C., 60 Hz wall outlet. Be sure plug fits tightly in
outlet. A loose connection may cause overheating and damage
to the plug or fan.
Note:
To prevent overloading a circuit, do not plug the fan into a
circuit that is servicing other electrical needs.
Turning Fan On:
Place fan on stable level surface. Plug fan
into properly grounded outlet. To start the fan, rotate the Power
Knob from the OFF position to the desired fan speed
HIGH,
MED,
LOW.
Turning Fan Off:
To turn the fan off, rotate the Power Knob
from the current fan speed setting to the off position. Remove
plug from outlet.
Adjusting Fan Tilt:
To adjust the angle simply tilt the fan to the
desired position.
Fan Wheel Assembly:
Assembly is required to assemble
wheels. Simply align two Wheel Clips to fan frame and push
them to attach as shown in Fig.3 and Fig.4.
Fan Feet Assembly:
Slide the feet into the space holder as
shown in Fig. 5. Align the holes on the feet with the holes on the
frame and screw the screws in. Fig 6.
Fig 3
Fig 4
Power
Knob
Fan Cradle Assembly:
Simple assembly is required to use
this fan.
1. Align Cradle Base (packed separately) with support brackets
attached to fan body sides. Note: you may need to flex the
parts to make them align properly.
2. Insert support bracket into opening of Cradle Base. Press
spring loaded button down to allow it to insert into Cradle
Base, see Fig 1.
3. Press support bracket into Cradle Base until spring button
protrudes out open hole in Cradle Base, see Fig. 2.
4. Repeat above process for opposite side of fan.
Fig 1
Fig 2
Spring
Button
Cradle
Base
Support
Bracket
Spring
Button
Fig 5
Fig 6
There is one small hole on each
side of the two cradle bases. The two small holes
should be kept inner side and at the same directions.
m
WARNING:
