Installation
42
Vidikron Vision Model 65/Model 75 Installation/Operation Manual
The anamorphic lens will almost always be angled with respect to the projector; this is
normal.
Once the proper lens angle has been set, firmly tighten the Pitch Adjustment Screws to
secure the lens in place.
Adjusting the Yaw:
Loosen the Yaw/Z-Adjustment Knobs to allow the lens to pivot freely
from side to side. Then, angle the lens to even out any left-right pincushion distortion:
Once the proper lens angle has been set, firmly tighten the Yaw/Z-Adjustment Knobs to
secure the lens in place.
There may be some pincushion distortion even after the lens is properly
adjusted, especially at shorter throw distances. If this is the case, Vidikron
recommends that you slightly over-scan the image into the screen frame
area to mask the distortion.
Note
Wrong Position
Correct Position
Anamorphic Lens (Top View)
Summary of Contents for Vision 65
