Installation
26
Vidikron Vision
8
5 Owner’s Operating Manual
PRE
L
IMINAR
Y
Installing the Fixed CineWide
Base Plate (Vision
85/CineWide)
To install the fixed CineWide base plate on a Vision
8
5/CineWide:
1.
Place the projector upside down on a blanket or other soft surface.
2.
If you are mounting the Vision 85/CineWide on a ceiling:
Position the left and right
ceiling mounting rails (provided with the Vision
8
5 ceiling mount kit) as shown in Figure
3-9. Position the CineWide base plate on top of the ceiling mounting rails so that the
outermost holes line up with the front mounting hole on each rail.
3.
Secure the CineWide base plate (and ceiling mounting rails, if needed) to the projector
with the four, 10-32 x 1/2" screws and washers provided with the CineWide lens base
plate. Note that you only need to use two washers if the Vision
8
5/CineWide is to be
ceiling-mounted.
4.
Use four (4) of the 10-32 x 3/
8
" screws provided with the Vision
8
5 ceiling mount kit to
secure the ceiling mounting rails to the projector.
Figure 3-9. Vision 85/CineWide with Anamorphic Lens Base Plate and Ceiling Mounting
Rails - Bottom View
➤
1. Do not use the mounting screws provided with the ceiling mounting kit.
Use only the hardware provided with the CineWide lens base plate.
2.
DO NOT OVER-TIGHTEN THE SCREWS.
Caution
Washers under
Base Plate
(2 places)
Washers under
Base Plate
(4 places)
Vision 85/CineWide with Lens Base Plate
Vision 85/CineWide with Lens Base Plate and
Ceiling Mounting Rails
