ENUK - V1.4 - 25/01/17
43
4000 Series GSM Audio Intercom - Technical Manual
4000 Series GSM Audio Intercom with Proximity
Programming the GSM Intercom
Example 1:
Find dial to open location of the telephone number using the full number
01234567890
, the following text can be
sent to the GSM PRO intercom:
1111FDT”01234567890”?
The GSM PRO intercom will reply with the following text:
STORED IN nnn
OK
VIDEX GSM
(where nnn = the dial to open location of where the number is stored).
Example 2:
Find dial to open location of the telephone number using the last 4 digits of the number
4567
, the following text can
be sent to the GSM PRO intercom:
1111FDT”4567”?
The GSM PRO intercom will reply with the following text:
STORED IN nnn
OK
VIDEX GSM
(where nnn = the dial to open location of where the number is stored).
FIND A FOB OR CARD (FDF)
The find a fob or card feature allows the user to search and find the fob/card location (between 000 - 999) of where a proximity fob
or card is stored in the GSM PRO intercom. It locates the fob or card using the 5 digit user code printed on the fob (see the following
example). The following text message can be used.
1111FDF”nnnnn”?
Find the fob/card location with user code nnnnn, where nnnnn = user code (5 digit user
code printed on fob/card).
Example:
Find fob/card location of card no.
12345
, the following text can be sent to the GSM PRO intercom:
1111FDF”12345”?
The GSM PRO intercom will reply with the following text:
STORED IN nnn
OK
VIDEX GSM
(where nnn = the fob/card location of where the fob/card is stored).
DOOR OR GATE (GAT)
This command feature of the GSM PRO allows the internal speech board to change the default speech annunciation that is heard
from the intercom when the onboard relay is activated. For this feature to be heard the internal speech board must be switched ON
(refer to notes on enabling or disabling the speech board,
SBM
, on page 42).
By default the mode of this feature is set to ‘01’, whereby the internal speech board will announce
“the gate is open”
when the
onboard relay is activated. The alternative mode can be set to ‘00’, whereby the internal speech board will announce
“the door is
open”
. To set the required mode the following commands can be sent to the GSM module.
1111GATnn
Set the speech board annunciation to mode nn: 01 or 00 (01 = “the gate is open”, 00 = “the
door is open”).
1111GATnn?
Set the speech board annunciation to mode nn: 01 or 00 (01 = “the gate is open”, 00 = “the
door is open”) also send a confirmation text back to sender.
1111GAT?
Query the speech board annunciation mode set.
SHUTDOWN AND RESTART (RBT)
This command feature allows the GSM PRO intercom to be remotely shutdown and then rebooted again. The following command
can be sent to the GSM module.
1111RBT
Shutdown and restart the GSM module.
IMPORTANT NOTE: This feature should not be confused with the ‘hard-wired’ reset (described on page 29). The RBT function
simply powers down the GSM module and then powers it back up again.
