66550070-EN - V6.5 - 15/06/21
- 27 -
ESVK/KRV782 Series “2 wire Bus” videokit
ESVK/KRV782 Series - Installation handbook
SURFACE MOUNTING
Fig. 1
Fig. 2
Fig. 3
135cm
Fig. 4
Fig. 5
Fig. 6
2
2
1
1
Fig. 7
Fig. 8
1. To install the videophone, it is necessary to remove the back cover. Apply pressure to the two clips indicated by the grey arrows
(Fig. 1) using fingers (Fig. 2) while lightly pulling the upper part in the direction of the white arrows (Fig. 3).
N.B. Repeat the same operation with both clips.
1. Protect the holes to fix the videophone to the flush mounting box then embed the flush mounting box in line with the wall in a
horizontal position at 135cm height from the floor as shown in Fig. 4;
2. As shown in Fig. 5 and Fig. 6, fix the back cover of the videophone to the flush mounting box keeping the same orientation
shown in the figure and taking care to feed the connection cables through the specific circular opening;
3. Connect the wires using a flat screw driver then setup the dip-switches as per provided connection diagram or instruction sheet
and fix the front part of the videophone to the back cover as shown in Fig. 7: hook first the bottom side then rotate the front part
and hook the upper side;
In order to avoid malfunctions, please do not over tighten the screws.
4. The video intercom is installed (Fig. 8), power up the system and check that it works correctly.
Kristallo Series
7" videomonitor wall mounting instructions
Summary of Contents for ESVK
Page 40: ...66550070 EN V6 5 15 06 21 40...
Page 41: ...66550070 EN V6 5 15 06 21 41...
Page 42: ...66550070 EN V6 5 15 06 21 42...
