VideoWave n-E4E, User Manual

Page: 21 / 73

21
Detection Area Setup : Select the sensitivity and the area to detect motion.
[ How to Setup the Motion Area ]
„ Entire Area : Checks the motion of entire camera image.
„
Partial Area : Click the “Add” button after selecting the “Partial Area”, and then drag the
mouse in the left screen to configure the area (maximum 10 partial areas can be added).
„ How to Delete the Partial Area : Click the “Select” tab, click the partial area to delete, and
then click the “Delete” button.
„ Delete All : Click the “Delete All” button to delete all partial area added.
[ How to Setup the Motion Detection ] => [ Sensitive 0 ---- 100 Insensible ]
„ Rate of Detection : the level of detecting unnecessary motion by noise, defaulted at 10.
„ Sensitivity : the level of detecting little motion in small point, defaulted at 10.
„ The motions are checked by both the rate of detection and the sensitivity for accuracy.
„ Click the “Test” tab to display the status of testing motions on the screen.
PanTilt Setup : Configure the PanTilt (rotational camera) to use.
„ Click the “Setup” tab to activate the following setup window.
„ Camera Selection : Select the camera the PanTilt is connected.
„ Receiver Setup : Check the “Enable” to activate the setup menu.
„ Select the port, type, communication speed, parity, data bit, and stop bit.
„ The configurations supported for the receiver or speed dome camera are listed in the table
4
5