41
Playback or search in the redundant disk.
There are two ways for you to playback or search in the redundant disk.
z
Set redundant disk(s) as read-only disk or read-write disk (Main menu-
>Advanced->HDD management). See
395H395H394H
Figure 4-13.System needs to reboot to get
setup activated. Now you can search or playback file in redundant disk.
z
Dismantle the disk and play it in another PC.
4.5
Motion Detect
4.5.1
Go to Motion Detect Menu
In the main menu, from Setting to Detect, you can see motion detect interface.
See
396H396H395H
Figure 4-14.
4.5.2
Motion Detect
Detection menu is shown as below. See
397H397H396H
Figure 4-14.
z
Channel: select the channel you want to implement motion detection.
z
Type: in the dropdown list, select motion detection item.
z
Record channel: select the channel to activate recording function once alarm
occurred. Please make sure you have set MD record in encode interface(Main
Menu->Setting->Schedule) and schedule record in manual record interface(Main
Menu->Advanced->Manual Record)
z
Enable tour: Here is for you to activate tour between different cameras.
z
Latch: when motion detection complete, system auto delays detecting for a
specified time. The value ranges from 10-300(Unit: second)
z
PTZ preset: Click set button, the interface is shown as in
398H398H397H
Figure 4-15.Here you
can set preset for one or more channels.
z
Region:
click
“
select
”
button to set motion detection region. See
399H399H398H
Figure 4-16.
z
Sensitivity: there are six levels. The six-level is of the highest sensitivity.
z
Alarm output: when alarm occurred, system enables peripheral alarm devices.
z
Show message: System pops up message in the screen to alert you once alarm
occurred.
Please highlight icon
to select the corresponding function. After all the setups
please click save button, system goes back to the previous menu.
Note:
In motion detection mode, you can not use copy/paste to set channel setup since the
video in each channel may not be the same.
In
400H400H399H
Figure 4-15, you can left click mouse and then drag it to set a region for motion
detection. Click Fn to switch between deployment and withdraw motion detection.
After setting, click enter button to exit.
