7
RC-U49C+ REMOTE CONTROL
(CONTINUED)
PROGRAMMING THE RC-U49C+ REMOTE CONTROL
Point and Press
®
Programming
This method allows you to program the remote control without using codes. Instead, the remote control automatically
finds the correct command that you select in a variety of codes until you find the code that operates your device. You
then lock in the correct code as described below.
When using this method, there are several important points to remember:
• The order in which you program your electronic devices is not important.
• There may be several codes that turn your electronic devices on/off (or perform other functions). Once you lock-in a
code, be sure to check the available functions for that device (i.e. TV - Vol+/-, Mute, TV Input (TV/VCR button),
VIDEO - Play, Stop, Rew..., AUDIO - Volume/Mute) to see if they are operating.
• While the remote is searching for the correct setup code(s) for your electronic devices, it is possible that other
(previously programmed) devices may turn on/off (or perform other functions). If this occurs, continue pressing the CH+
or CH- buttons until you find the correct code for the device you are programming.
• It may take several minutes for the remote to find the correct code that turns your device on/off (or performs another
selected function). During this time, the POWER/MODE buttons will illuminate in fast-rotation (i.e. CBL > TV > VIDEO >
AUDIO > CBL..).
Programming your electronic devices using CH+ or CH- buttons (Point and Press
®
method)
1. Turn on all the electronic devices (TV, VCR, DVD, AUDIO) you want to program the remote to operate.
2. On your remote control, press and hold SELECT, then MUTE together until the POWER/MODE buttons illuminate
in slow rotation (i.e. CBL > TV > VIDEO > AUDIO > CBL..).
3. Press and hold the CH+ button until one device turns off. While you are pressing the CH+ button, the POWER/MODE
buttons will illuminate in fast-rotation. As soon as one device turns off, release the CH+ button.
4. Press MUTE button.
a. If the device that turned off... turns back on, press SELECT to lock in this code.
The POWER/MODE buttons will blink 3-times and go out.
or
b. If the device that turned off... does not turn back on, press CH- one step at a time until that device turns back on.
Each time you press the CH- button, the POWER/MODE buttons will illuminate once in reverse fast-rotation
(i.e. AUDIO > VIDEO > TV > CBL).
5. Once you have found a code that turns the device on/off, press SELECT to lock in this code. The POWER/MODE
buttons will blink 3-times and go out.
6. Repeat steps 2 to 5 above for each of the remaining electronic devices you wish to program the remote to operate.
