Videotec WASPT, Instruction Manual

Page: 10 / 134

EN - English - I
nstruc
tion manual
8 MNVCWASPT_2045_EN
6.2 Choosing the power supply
Depending on the version, the device can be
provided with different power supply voltages. Their
value is shown on the product identification label.
Electrical connections must be performed
with the power supply disconnected and
the circuit-breaker open.
When commencing installation make sure
that the specifications for the power supply
for the installation correspond with those
required by the device.
Check that the power supply socket and
cable are adequately dimensioned.
Use a power cable that is suitable for
outdoor use (example: H05RH-F).
6.3 Open the box
Open the cover of the water-proof box and connect
as described below.
Fig. 6
6.4 Board description
BOARD DESCRIPTION
Connector Function
J1 Power supply for the board
J7 Wiper
J8 Optional board (DTWRX)
J9 I/O management and pump functions
FUS1 Power supply selection fuse (230Vac)
FUS2 Power supply selection fuse (120Vac)
FUS3 Power supply selection fuse (24Vac)
Tab. 1
J9
J7 J1
J8
FUS3
FUS2
FUS1
Fig. 7