Videotec VD816PR1, Operating Instructions Manual

Page: 12 / 56

Pag. 6 MNVCVD816P_1729_EN
6.2.1 Modification of inputs/outputs selections
By this procedure, it is possible to connect the inputs in parallel in order to obtain personalized configurations.
These are the different versions which can be obtained:
Configuration A Configuration B Configuration C Configuration D
Input 1 – Outputs 1 / 2
Input 2 - Outputs 3 / 4
Input 3 - Outputs 5 / 6
Input 4 - Outputs 7 / 8
Input 5 - Outputs 9 / 10
Input 6 - Outputs 11 / 12
Input 7 - Outputs 13 / 14
Input 8 - Outputs 15 / 16 Input 1 - Outputs 1 / 2 / 3 / 4
Input 3 - Outputs 5 / 6 / 7 / 8
Input 5 - Outputs 9/10/11/12
Input 7 - Outputs 13 / 14 / 15 / 16 Input 1 – Outputs 1 / 2 / 3 / 4 /
5 / 6
Input 4 – Outputs 7 / 8
Input 5 – Outputs 9 / 10 /11
/12 / 13 / 14
Input 8 – Outputs 15 / 16 Input 1 – Outputs 1 / 2 / 3 / 4 /
5 / 6 / 7 / 8
Input 5 – Outputs 9 /10 / 11 /
12/ 13 / 14 / 15 /16
JUMPER NOTE
The jumpers signed with A (exemple J1A, J3A) are relevant to the first 8 outputs while the jumpers signed with B
(exemple J5B, J7B) are relevant to the last 8 outputs.
•
Configuration A selection (standard selection) :
Where to operate : Jumpers J1A, J3A , J5A , J7A, J1B, J3B , J5B , J7B
Selections : put the jumper only in J1A, J3A , J5A , J7A, J1B, J3B , J5B , J7B
•
Configuration B selection:
Where to operate : Jumpers J1A, J2A , J5A , J6A, J1B, J2B , J5B , J6B
Selections : put the jumper only in J1A, J2A , J5A , J6A, J1B, J2B , J5B , J6B
•
Configuration C selection :
Where to operate : Jumpers J1A, J2A, J4A , J7A, J1B, J2B, J4B , J7B
Selections : put the jumper only in J1A, J2A, J4A , J7A, J1B, J2B, J4B , J7B
•
Configuration D selection:
Where to operate : Jumpers J1A, J2A , J4A , J6A, J1B, J2B , J4B , J6B
Selections : put the jumper only in J1A, J2A , J4A , J6A, J1B, J2B , J4B , J6B
6.2.2 Output gain adjustment
Where to operate : Trimmers TR1A…TR8A, TR1B…TR8B
Selections: Adjust the Trimmers corresponding to each video output connected