Videotec NXMTUB, Instruction Manual

Page: 4 / 20

EN - English - I
nstruc
tion manual
2 MNVKNXMTUB_2222_EN
5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
warranty.
5.1 Unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
When returning a faulty product we recommend
using the original packaging for shipping.
Keep the packaging in case you need to send the
product for repairs.
5.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Sunroof
• Bolts and screws
5.3 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
6 Installation
If previously installed, remove the
sunshield and washer nozzle from the
camera.
Align the dust prevention sunshield with the 4 screw
holes on the front of the housing.
Fix the dust cover (01) to the front of the housing
by means of 2 of the 4 screws and washers supplied
(02).
01
02
Fig. 1
Pay attention to the fixing. Tightening
torque: 4.5Nm.
If you need to install the sun canopy, do the
following.
Between the sunshield and the flanges of the
housing, position the spacers supplied. Fasten
the sunshield to the housing with the screws and
washers supplied, corresponding to the spacers.
Fig. 2