Videotec DCJ, Operating Instructions Manual

Page: 149 / 256

Page 19
MNVADCJ01_1729
_EN




Normally camera with pan & tilt is assigned a receiver/dome with the
same number (camera 1, receiver 1, camera 2, receiver 2, etc.)
Under particular circumstances (while installing composit
systems for example) it may be necessary to assign a receiver
with a different number from that of the camera.
In the example given receiver 12 is to be assigned to camera 3,
and the receiver should be controlled on telemetry line B.
Scroll the list to find the camera to have a new setting and press

to proceed with the change.





The

column shows a cursor: it is expecting insertion of the
receiver/dome number assigned to the camera. Press

to assign receiver 12.





After inserting the receiver number, if the keyboard is set up to
control two different telemetry protocols the menu will ask on
which line (A or B) the receiver is connected.
Press

to assign line A,

for line B.





After completing modification, pressing

will return to the
previous menu and then again on up to the main menu.
The icon of the 1-10 set has now been changed to

to show that
only some of the cameras in the group are now accepted.

4.5.5 Notes concerning assigning the receivers
After the receivers have been assigned in the menu, the

key will be automatically disabled (if it is to be re-
enabled see
§ 4.5 - Accepting requests for cameras and assigning receivers, page 16.
4.5.5.1 Using the EL.MO. DVR
If one of the video protocols, EL.MO. DVR 9 or EL.MO. DVR 16, has been selected, on exiting the VIDEO
COMUNIC.LINE submenu the keyboard will associate the receiver number and the camera number according
to the mapping described in the EL.MO. protocol. (DVR 1 Cameras 1

16, DVR 2 Cameras 17

32, etc.) and all
cameras to Telemetry line A. If for some reason it is necessary to associate camera-receiver or telemetry line
differently (ACCEPTED VALUES menu /Cameras/Receivers / Change list), make sure that the cameras
associated with DVR No. XX (where XX is from 01 to 14) have the address XXyy (where yy is from 01 to 16).
This is why all cameras with an address between 0001 and 0100 will be disabled.
For example: camera No. 1 associated with DVR No. 1 will have the address 0101 ( and not 0001 ) and it is
associated with receiver No. 001.
Camera No. 1 associated with DVR No. 1 will have the address 0201 and it is associated with
receiver No. 017.
4.5.6 Warning message
If a disabled camera is requested, the display will show a message warning the operator that the request is not
authorised:



