12
INSTALLATION MANUAL
2. XTO-IP PANEL PROGRAMMING
XTO-IP
Alarm panel
PRESS PROGRAM
BUTTON OF DEVICE
RECORDING
DEVICES
ENTERING A NEW DEVICE ?
BADGE ENTERED ?
RECORDING A
NEW BADGE ?
END OF
CONFIGURATION
Each device has a unique programming button or a
specific manipulation. Please refer to the Installation
Sheet for the device you would like to program.
Please check the radio level of each device on its
final location. The result must be 8 out of 9 as a
minimum (Please refer to the Radio Range section,
page 8 for further details).
Each system can embrace a maximum of 25 devices,
programming keypad included.
Press
OK or YES
to enter a new device or
ESC NO
to
move to the next step.
ESC
NO
ESC
NO
ESC
NO
After initial programming has been completed, the
system cannot be armed or disarmed until a user
code or badge is entered (the installer code cannot
arm or disarm the system).
Press
OK or YES
to register one or more badges.
ESC NO
if you’re not using any badges.
If you wish to use an user code, please skip this step
and when initial programming is completed go to
the BADGES/ACCESS CODES menu (please refer to
chapter 4.5 for further details).
Badges and codes are limited to 19 for user (level 2
or 3) + 1 installer code.
OK
or
YES
OPERATION
COMPLETED ?
SYSTEM CHECK
IN PROGRESS
INSTALLATION SUCCESSFUL !
Before completing programming make sure that no
device is tampered. Each device must be closed and its
LED indicator shall be turned off.
After initial programming has been completed, make
use of the menu overview document (available on our
technical support website), to see full programming
options.
OK
or
YES