5.8GHz All Weather 8 Channel Series Manual Rev. J
3
SAFETY NOTICES
I. THIS DEVICE COMPLIES WITH FCC RULES PART 15. OPERATION IS SUBJECT
TO THE FOLLOWING TWO CONDITONS:
(1)
This device may not cause harmful interference, and
(2)
This device must accept any interference, including interference that
may cause undesired operation of the device
II. In order to comply with the FCC/IC adopted RF exposure requirements, this transmission
system will be installed by an authorized professional installer of VideoComm
Technologies. Installation of all antennas must be performed in a manner that will provide
at least 23cm clearance from the front radiating aperture, to any user or member of the
public.
III. This is NOT an intrinsically safe device. Do not take into area where intrinsic safety is
required. Bodily harm may result if warning is ignored.
IV. DO NOT OPERATE TRANSMITTER WITHOUT ANTENNA CONNECTED TO
ANTENNA PORT. Failure to do so will result in damage to the unit and void the
warranty.
V. DO NOT OPERATE THE TCO-5800 SYSTEM WHEN the Transmitter & Receiver are
closer than ten feet to each other. The devices may not work properly and permanent
damage can occur.
VI. The TCO-5800 has been certified by the FCC for use with other products without any
further certification (as per FCC section 2.1091.) Changes or modifications not expressly
approved by VideoComm Technologies could void the user’s authority to operate the
equipment.
The term “IC:” before the radio certification number only signifies that Industry Canada
Technical specifications were met.