Day-Night Camera Series Manual Rev.D 2013
3
SAFETY NOTICES
I.
WIRELESS CAMERAS COMPLY WITH FCC RULES PART 15. OPERATION IS SUBJECT
TO THE FOLLOWING TWO CONDITONS:
(1)
This device may not cause harmful interference, and
(2)
This device must accept any interference, including interference that
may cause undesired operation of the device
II.
In order to comply with the FCC/IC adopted RF exposure requirements, the wireless camera
systems must be installed by an authorized professional installer of VideoComm Technologies.
Installation of all antennas must be performed in a manner that will provide at least 23cm
clearance from the front radiating aperture, to any user or member of the public.
III.
This is NOT an intrinsically safe device. Do not take into area where intrinsic safety is required.
Bodily harm may result if warning is ignored.
IV.
DO NOT OPERATE WIRELESS CAMERAS WITHOUT AN ANTENNA CONNECTED TO
ANTENNA PORT. Failure to do so will result in damage to the unit and void the warranty.
V.
DO NOT OPERATE THE WIRELESS CAMERAS WHEN the Camera & Receiver are closer
than ten feet to each other. The devices may not work properly and permanent damage can
occur.
VI.
The Wireless Cameras have been certified by the FCC for use with other products without any
further certification (as per FCC section 2.1091.) Changes or modifications not expressly
approved by VideoComm Technologies could void the user’s authority to operate the equipment.
Industry Canada 3677A-T5808VCT
