Put-in
D
rive S
cre
ws
Flush Box
Cable
(
1)Frame part
：
Surface-mount the frame part
Make holes for the screw by wall plastic expasion plug and fasten the screws
according to the hole of the frame part.
(2)The recommended height of 150CM helps the camera for proper monitoring
range. First , put the clasp in the frame with four screws, then secure the
frame into the wall.
(3)Connect the wires from the camera unit to the monitor wiring terminal.
(4)In the end install the outdoor section in the frame as depicted on the figure
below. Tighten up screw from the bottom.
plastic
expansion
plug
S
c
r
e
w
3
)
ODS-A
Put-i
n
Self-Tapping Screws
Drive Screw
Tab
Cable
Pop-out
Bracke
t
①
Drill a hole in the center area of the bracket just big enough for the electrical
wiring to pull through. And drill 2 small holes for the plug bolts.
②
Insert and fix the plug bolts in the 2 small holes, then attach the mounting
bracket to the wall and fix with 2 self-tapping screws.
③
Pull the wiring which connect to Monitor Unit through the central hole and connect
well with Terminals “V, GND, A & +”. Also prepare 2 wires to connect with Lock
Connectors “
UNL+ & UNL-” and pull through Bracket and central hole in the wall
and connect with the door lock.
④
Put the wired Camera Unit in the bracket and pop out the tab at the bottom of
the unit. Fix it with drive screw and press back the tab.
4) ODS-J
Attention:
It is suggested that owners delete photos kept regularly for photo-memory
only model with SD built-in to hold thousands of photos for better
performance.
The handled objects are photos when the function setting is photo and it is
video when the function setting is video for photo/video both recording
model.
The system should be power off each time to refresh after downloading
files by the USB port for all the video door phone models with memory
function.
