5
the associated button’s LED will illuminate along with the ▼/▲ (-/+)
buttons.
5
+/- & ▲/▼:
Press to move up and down or adjust selections within
menus. These buttons will illuminate when the selected function
has values that can be adjusted up or down.
6
PATTERN:
Within Pattern mode, press to enable selection of the
test pattern used. The ▼/▲ buttons will illuminate and are used
to select the new pattern. The new test pattern will automatically
become active after selecting it and pausing for 2 seconds.
Additional variations (if available) are selected by pressing the
button additional times. Within Analyzer mode, press to turn on/off
a “title-safe/action-safe” overlay.
7
TIMING:
Press to enable selection of the output timing and
resolution used. The ▼/▲ buttons will illuminate and are used to
select the new timing. The currently selected timing will be shown
on the OLED display. The new timing will automatically become
active after selecting it and pausing for 2 seconds.
Note: In Analyzer mode, please select the “Bypass” timing if you
do not wish for your source’s output signal to be scaled by the unit
before being sent to the display. The LED will blink Red when the
timing is set to Bypass.
8
ANALYZER/PATTERN:
Press to switch the unit between Analyzer
Mode (LED=Red) and Pattern Mode (LED=Blue). When in Analyzer
Mode, press and hold the button for 2 seconds to force an RX
hot-plug. When in Pattern Mode, press and hold the button for
2 seconds to turn on/off the AVMute bit within the output’s GCP
(General Control Packet).
FACTORY RESET:
Press and hold this button while powering the unit
on to perform a factory reset of the unit.
9
EDID PATTERN:
Press to enable selection of the EDID to use on the
HDMI input port. The ▼/▲ buttons will illuminate and are used to
select the new EDID. The currently selected EDID will be shown on
the OLED display. The new EDID will automatically become active
after selecting it and pausing for 5 seconds.
10
AUDIO LPCM:
Within Analyzer mode, press to select which digital
audio source pair (0-3) is routed to the primary stereo channel
(LPCM 2.0 and headphone output) for monitoring. The LED color
indicates the selection (Off=SD0, Red=SD1, Blue=SD2, Purple=SD3).
Summary of Contents for MONTEST-HD4K
Page 1: ...MONTEST HD4K 4K HDMI Video Test Pattern Generator Operation Manual Operation Manual...
Page 2: ......
Page 56: ......
