ANTI-VANDAL 10x SPEED DOME CAMERA
92/96
How do I find out my IP address information if my settings were
automatically detected?
Windows 98 / ME Users
①
Open an MS-DOS Prompt
②
At the prompt type:“winipcfg” (without the quotation marks)
③
Use the drop down list to select your 10/100 Ethernet Adapter (not a PPP adapter)
④
Now you will see your IP Address, Subnet Mask, and Default Gateway information
⑤
For DNS information contact your Internet Service Provider
Windows 2000 / XP Users
①
Open a Command Prompt
②
At the prompt type - “ipconfig /all” (without the quotes)
③
Near the end of the information supplied, should be your current IP address, subnet mask, default
gateway and DNS servers
How do I choose a private IP address
:
Assign your IP Speed Dome a private IP address that matches your current network. Below lists
the ranges for private addresses:
Private Class A address space : 192.168.0.0 - 192.168.255.255
Private Class B address space : 172.16.0.0 - 172.31.255.255
Private Class C address space : 10.0.0.0 - 10.255.255.255
My POWER light is not on?
Power is not being supplied to the unit. Please use the power supply shipped with the unit and
verify that a power source is active from the attached power outlet used to connect the adapter.
You can test this by plugging in any other electrical device and verify its operation. After using
the power supply shipped with the product, checking the power source, and reinserting the
power connector into the IP Speed Dome, please call our Support Center. The power supply may
be defective.
My ACTIVE light is not flashing?
Verify the power supply to the unit. Power off the unit and back on again, wait 1 minute, if the
ACTIVE light still does not begin to flash, you will have to set the unit to its factory default (THIS
WILL DELETE ANY CONFIGURATION AND SET THE UNIT TO THE FACTORY DEFAULTS). Power
on the unit and insert the end of a paper clip into the small recessed opening on the back of the
unit. Use the clip to press the button located within that opening.
FAQ
9
