ANTI-VANDAL 10x SPEED DOME CAMERA
61/96
Starting IP Speed Dome
After correctly forwarding the Web Server Port , Video Server Port, Control Server Port and two Audio
Ports through your router (if applicable), you may then install the IP Speed Dome in a proper location.
①
Locate the serial number located on the label attached to the bottom of the IP Speed Dome,
you will need this for DDNS registration.
②
Connect the IP Speed Dome to your router or cable/DSL modem (per your network scenario)
via a Cat5/5e UTP Ethernet network cable.
③
Supply power to the IP Speed Dome.
④
After 50 seconds, verify the IP Speed Dome indicators:
⑤
After configuring Port Forwarding on your router (if necessary), you may then access your IP
Speed Dome on your local network by opening Internet Explorer and specifying the IP
address and Web Server Port that you have assigned to the IP Speed Dome.
Examples: http://192.168.0.200:8888 or http://24.106.88.123
if you left your Web Server Port set to 80, then you don’t need to specify the port in the
Address Bar when accessing the IP Speed Dome.
⑥
Access your IP Speed Dome via the Internet:
If you use Case B or C
i) Open Internet Explorer.
ii) Type the IP of the IP Speed Dome.
If you use Case A, D, E
i) Open Internet Explorer.
ii) Visit the DDNS website.
iii) Register the IP Speed Dome.
iv) Give the DDNS server 10 minutes (MAX) to locate your IP Speed Dome’s IP
information. You may reboot the server to send an immediate request to our DDNS
server.
v) After your camera is connected, select your camera.
ACTIVE
Flashing
LINK
Flickering/Solid
NETWORK SETUP
5
