background image

 

FCC Statement

 

1.This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions:
     (1)This device may not cause harmful interference, and 
     (2) this device must accept any interference received, including interference that may 
          cause undesired operation.
2.Changes or modifications to this unit not expressly approved by the party responsible for 
compliance could void the user authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for Class B 
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:

     - Reorient or relocate the receiving antenna.
     - Increase the separation between the equipment and the receiver.
     - Connect the equipment into an outlet on a circuit different from that to which the 
       receiver is connected.
     - Consult the dealer or an experience radio/TV technician for help.

 

CALIFORNIA PROP 65 WARNING

 

IC WARNING

12

This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). 
Operation is subject to the following two conditions:
        1. This device may not cause interference.
        2. This device must accept any interference, including interference 
              that may cause undesired operation of the device.
This equipment complies with FCC and IC radiation exposure limits set forth for an 
uncontrolled environment. This equipment should be installed and operated with 
minimum distance 20cm between the radiator & your body.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est 
conforme aux CNR d’Innovation, Sciences et Développement économique Canada 
applicables aux appareils radio exempts de licence. 
L’exploitation est autorisée aux deux conditions suivantes :
        1. L’appareil ne doit pas produire de brouillage;
        2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le 
              brouillage est susceptible d’en compromettre le fonctionnement.
Cet appareil est conforme à FCC et IC l’exposition aux rayonnements limites fixées 
pour un environnement non controlé. Cet appareil doit être installé et utilisé avec 
une distance minimale de 20 cm entre le radiateur et votre corps. Cet transmetteur ne 
doit pas être co-situé ou opérant en liaison avec toute autre antenne ou transmetteur.

Summary of Contents for VTA-72
















Reviews: