10
Caution:
-
Do not remove/bend the stylus needle and do not touch the needle to avoid injury.
-
Turn off the unit’s power before you replace the stylus and keep out of reach of children.
LISTENING TO MUSIC VIA RCA LINE OUT
1. Connect one end of the RCA line out cable to either the AUX-IN, LINE IN or PHONO IN sockets
on your external speaker device. Connect the other end to the OUTPUT socket on the back of the unit.
2. If you are connecting via PHONO IN from your external speaker system, the PRE-AMP switch should
be turned OFF.
3. If you are connecting via AUX-IN or LINE IN from your external speaker system, the PRE-AMP switch
should be turned ON. Improper setting of PRE-AMP switch may lead to no sound or loud unwanted
feedback.
Note:
Be sure to connect the white plug to the white jack and the red plug to the red jack.
CONDENSATION WARNING:
When the unit is moved from a cold or warm place, or is used following a sudden temperature change,
there is the danger that water vapor in the air may condense on the unit, preventing proper operation.
In such cases, leave the unit for 1-2 hours after plugging it into an AC outlet to allow it to stabilize at the
temperature of its surroundings.
LISTENING TO MUSIC VIA BLUETOOTH OUT
1. Turn ON the unit and turn ON your external Bluetooth device.
2. Press the PAIR
button to connect to your external Bluetooth device.
3. The Bluetooth LED Indicator will begin flashing, indicating the unit is searching for an external device.
4. The turntable will then auto pair with your external Bluetooth device. The LED will remain lit and an
audible chime will ring indication a successful connection.
5. You can adjust the sound level on your external Bluetooth device or press the VOL- or VOL+ button
on the turntable.
6. Press and hold the PAIR button to disconnect from your external Bluetooth device, LED indicator
will turn OFF.
Note:
If the turntable does not pair with the external Bluetooth device, turn OFF both the turntable and
the device and reattempt the procedure above.