GENERAL
1.8
Multi--Function Display (MFD) Modes and Operation
The MFD lets the user toggle via the mode button to view the odometer, the trip odometer, the clock, the fuel
gauge, the voltmeter, the instrument cluster light dimmer, the headlamp high beam indicator light dimmer, and
the check engine indicator. The MFD operates only when the ignition switch is in the
On
position. To select
the desired function, press the MFD
Mode
button (A). To adjust a particular function, press the MFD
Set
button (B).
A
RH Front View
B
LH Front View
A
RH Front View
Set
Mode
Odometer
The odometer is the default mode of the MFD after starting the engine and displays the total miles traveled.
To toggle the odometer and trip odometer reading between miles / kilometers, and the fuel gauge reading
between gallons / liters, the ignition switch must be in the
On
position with the MFD in odometer mode. Press
and hold the MFD
Set
button for 3 seconds.
To change to the next MFD function, press the MFD
Mode
button.
Trip Odometer
“TRIP” appears as part of the display when in trip odometer mode. The trip odometer shows total miles
traveled since the trip odometer was reset. You can use the trip odometer to calculate the miles per gallon and
estimate the number of miles traveled on a tank of fuel.
To reset the trip odometer, the ignition switch must be in the
On
position with the MFD in trip odometer
mode. Press and hold the MFD
Set
button for 3 seconds.
To change to the next MFD function, press the MFD
Mode
button.
Clock
A clock icon appears as part of the display when in clock mode. When the clock is operating normally, the
colon between the hour and minutes flashes.
To set the clock, the ignition switch must be in the
On
position with the MFD in clock mode.
1. Press and hold the MFD
Set
button for 3 seconds when in clock mode. The hour digits should flash.
2. Press the MFD
Set
button to select the desired hour.
3. Press the MFD
Mode
button to accept the new hour setting. The ten--minute digit should flash.
4. Press the MFD
Set
button to select the desired ten--minute.
5. Press the MFD
Mode
button to accept the new ten--minute setting. The minute digit should flash.
6. Press the MFD
Set
button to select the desired minute.
7. Press the MFD
Mode
button to accept the new minute setting. The clock should return to normal
operation, and the colon should flash.
To change to the next MFD function, press the MFD
Mode
button.
Notice
The clock will not function if the battery voltage drops below 11.5 volts. The clock will reset to
12:00 if the battery is disconnected.
