Page 8 of 8
Qd-00029.doc
Version 12.06.07
Setting combinations (Temperature menu)
Press the Victorinox emblem for
8
seconds until
the display flashes. Release the Victorinox
emblem again. You have now changed over to
the unit setting mode. By pressing the Victorinox
emblem briefly while the display is flashing, the
temperature and altitude units can be changed
(see illustration).
If the button is not pressed for
3
seconds, the
setting mode is quit automatically and the new
setting accepted.
Battery operating voltage
The background lighting consumes the most
current. If the battery voltage drops below a
specified value, the background lighting is
switched off (or not switched on at all). When the
next menu change occurs, the display shows
"noLi" (no light). The background lighting can be
switched on again if the battery voltage rises.
In normal operation, the battery voltage is meas-
ured at 15 minutes intervals or whenever the
menu is changed. If the voltage falls below 2.2 V
when measured 4 times, at the next menu
change the "LoPo" (low battery power) message
appears. The battery should be replaced soon.
The electronic functions continue to operate until
the battery is fully depleted.
Battery change
The electronic system is fitted in the factory with
one, and the LED module with two, 3 volt lithium
batteries - type CR1225. Before replacing the
batteries in the LED module, the module must
first be swung out and the housing cover ejected
from the back using the mini-screwdriver. The
mini-screwdriver can also be used to open the
swivelling battery compartment for the electronic
system (see illustration).
Celsius / Meter
Celsius / Feet
Fahrenheit / Meter
Fahrenheit / Feet
LED module
(for Traveller Lite only)
Electronic
