Victor iCNC XT, Operating Manual

Page: 95 / 110

iCNC XT
Manual 0-5299 OPERATION 5-37
5.13.3. Line Marking
Marking speed
This is the speed selection for the marking tool.
Tool location (X and Y)
This is the marker location measured from the torch or laser pointer.
SD1 and SD2
These delays are typically not used, but are fully available and programmable.
SD3
Typically used for a marker down delay. This is the time that it takes for the marker to descend to marking height.
SD4
Typically used for igniting the marker.
Move Delay
This delay is typically not used.
ED1
Typically used for marker up.
ED2
This delay is typically not used.
Move Delay
This is the time that the controller waits after the marking is completed, before commanding the machine to move to the next position.