Victor iCNC XT, Operating Manual

Page: 55 / 110

iCNC XT
Manual 0-5299 OPERATION 4-1
SECTION 4: QUICK START AND OPERATION
WARNINGS
DO NOT CONNECT the controller directly to a computer through the RJ45 or RS232 port! Connections must
be made with fiber optic devices, wireless LAN, short haul modems or other approved devices which provide
galvanic isolation, due to ground loops, electrical noise, or high frequency which can destroy electrical
components in the controller or host computer. Failure to follow these rules will VOID THE WARRANTY!
This device is an enclosed type AC Servo Driver with single-phase input and three-phase output. This device
is provided with an integrated PLC and a Windows based user interface.
1. Use minimum 75 ºC copper wire only
2. Use Copper Conductors Only
3. Suitable for use on a circuit capable of delivering not more than 5000 rms symmetrical Amperes, 230
Volts maximum.
4. Solid state motor overload protection is provided in each model at 110% of rated FLA.
5. Integral solid-state short circuit protection does not provide branch circuit protection. Branch circuit protection
must be provided by any R/C supplemental fuse (JDYX2), rated 250 Vac, 10 A.
4.1 Quick Guide for Part Cutting
This section will give a quick demonstration on cutting a part.
1. Verify that the machine is in cutting condition and you have correct consumables installed in the torch.
2. Select the thermal screen from the bottom tool bar.