028-0506-02_II-VZ8250_EN www.viconics.com
January 2020
Figure-1 Open the cover
Figure-3 Reinstall cover
Figure-2 Install the base
6
VZ8250
[
Installation Guide
]
2. INSTALLATION
1. Remove the security screw (if applicable) from the bottom of the
Room Controller cover.
2. Open the unit by pulling on the bottom side of the Room
Controller (Figure 1).
3. Read the FCC ID and IC label installed inside the cover before
installing any wireless product.
4. Ensure the correct side of the base faces up.
5. Pull the cables 6in (15cm) out from wall.
6. Align the base and mark the location of the two mounting holes
on the wall.
7. Install the anchors in the wall (Figure 2).
8. Insert the cable in the central hole of the base.
9. Insert the screws in the mounting holes on each side of the
base.
10. Strip each wire 1/4in (0.6cm) from the end.
11. Insert each wire and screw according to the wiring chart (see
following pages).
12. Gently push excess wiring back into the hole.
13. Gently align the cover with the top of the base and snap it into
place from the bottom (Figure 3).
14. Install the security screw (if applicable).