Model VI-DSP-2 Encoder
Installing the Encoder
11
Installation
Mount the encoder in a level, clean and dry indoor location on a shelf on in a rack.
The room or area temperature is climate controlled for human occupancy Connect
power supply, network cable, video cables and ground as follows. A typical
network installation is shown in the following figure.
WARNING
Disable the AC power to prevent installer injury and damage to the unit. Ensure all
connections are made prior to powering the unit.
Connecting the Cabling
Perform the following connections (refer to front and rear panel illustrations):
1.
Insert one side of a standard LAN cable to the rear panel ETH RJ-45 connector.
Insert the other RJ-45 connector into the LAN side of the network (switch, wall
jack, etc.).
2.
Connect camera video output cable to front panel VIDEO IN1 connector.
Connect VIDEO OUT cable to DVR video input.
3.
Connect TTL input and/or relay outputs to rear panel TTL IN/OUT connector.
Summary of Contents for VI-DSP-2
Page 2: ......