29
4.3.1 Network Settings
IP mode: There is support for both IPv4 and IPv6 modes. The configuration of
Network parameters will differ depending on the mode selected.
Figure 4-
11
Network Settings
Users can enable (On) or disable (Off) DHCP. When it is disabled, users can set
unit IP address, Subnet mask, Gateway and DNS server IP address manually.
Note:
The system indicator quickly flickers for 5 seconds after the network
settings are completed successfully.
Enter Host name and Port settings for Onvif, Http and Https.
Users can enable/disable PPPoE in this interface. If enabled, users can set the
user name and password.
Telnet service can be turned On or Off as required.
In SNMP settings, the cameras support a heartbeat function. Set and save the
Heartbeat server IP address and Heartbeat interval; the heartbeat package will be
sent to the server or client, which greatly facilitates the server or client to know
about the camera’s network status.
Be sure to save settings before leaving the interface or cancel any changes made.
