Vicon SVFT-PRS22E, Installation And Operation Manual, Page: 30 / 44

24
•
Uninstalling XX163-11-00 Rev 1006 SVFT-PRS Pressurized Dome Housing
ViconNet (IP/LAN) Version Operation
The following functions are supported by the ViconNet system through a workstation, recorder or server.
1. System macros can be configured to view and record the dome’s video. In addition, within macros, alarms
can be sent and remote macros triggered.
2. An alarm can be triggered upon video motion detection and video loss. This alarm can be sent remotely
to other networked units.
3. PTZ control can be performed from any networked workstation, recorder or server. Authorization for PTZ
can be assigned to specific operator levels.
Refer to the ViconNet workstation manual XX113 for complete information on operation. A copy of the
manual can be found on the CD included.
Uninstalling
If it becomes necessary to uninstall to SVFT-PRS, follow the steps below.
WARNING: Before starting to uninstall the unit, be sure to release all the pressure through the fill valve on the
side of the unit.
1. Unscrew the eight (8) captive screws holding the lower dome assembly in place. The O-ring holds the unit
place so it will not drop.
2. Using a flat head screwdriver, work around each of the four (4) slots provided to remove the lower
assembly. The lanyard will hold the assembly; unclip the lanyard if you want to completely remove the
lower assembly.
3. To reassemble the unit, tighten each screw until snug in a criss-cross pattern (opposite screw) and then
tighten each screw securely.