Vicon surveyor 1000, Installation & Operation Manual

Page: 35 / 62

XX100-00-01 Rev 202 Surveyor1000 Camera Dome System Wiring
••••
29
WARNING: If Vicoax mode is being used, DO NOT wire TB3 for control, as this will cause the Camera
Dome Program to lock up upon power-up.
6. Reinstall the Terminal Blocks
TB1 and TB3 into the
Communication Power Supply
Board at the proper block
frames.
7. Install the video BNC cable
connector to the
Communication/Power Supply
Board’s mating BNC
Connector.
8. Plug in all RJ-45 cable
connectors to their
corresponding mating
connectors J1 and J3.
WARNING: Failure to insert the RJ-45 Connectors into the correct mating connectors can cause damage
to the Communication Power Supply Board upon power-up.
9. Place each cable into the
Enclosure’s Cable Retainer (for
the Outdoor version, under the
Fan Bracket as shown in Figure
23.) The Safety Cord should
now provide sole support of the
Surveyor1000 and the cables
should be slack and
comfortably run to their
connectors. Push any
remaining cable back through
the top of the Housing until the
cabling comfortably passes
directly from the Cable Clamp
(Fan’s Bracket) to the top of the
Housing.
Figure 22
Indoor Pendant Mount Cable Installation
Figure 23
Outdoor Pendant Mount Cable Installation