Vicon SMS Enterprise, Installation & Operation Manual

Page: 13 / 16

10
NOTE : The default IP address of an Enterprise controller is 192.168.0.250. If you changed
this in previous steps then enter the new address here.
4. At the Login page enter the User name “admin.”
5. Enter the Password “admin.”
6. Click Go . The security application will now display.
7. Select Setup : System Maintenance : Restore System .
8. Click the link provided to upload the backup you previously made. Browse to the location of
the system backup file and click Save . The backup should now appear on the Restore
System page.
9. Click the button in the Restore? column next to the backup you wish to restore.
10. Click Restore Now .
11. When the system restore has completed you will be logged out.
Login and Swap the Unique Identifiers of the removed and newly installed Nodes
1. Log back in to the Enterprise controller.
2. Select Setup : Site Settings : Network Nodes .
3. Select from the Name drop-down the node which you removed.
4. Click the Commands tab.
5. Click the Swap button.
6. In the dialog box select from the drop-down the newly installed node.
NOTE : If other nodes are powered you may need to know the Unique identifier for this new
node to make the correct selection. You can use nnconfig.exe to get this UID.
7. Click Save and confirm the swap in the popup.
NOTE : Since resources (inputs, outputs, readers, etc.) are specific to a node unique
identifier, the Swap you performed in this procedure has reassigned the old node’s resources
to the new node.
8. Select Setup : Site Settings : Network Nodes .
9. Select from the Name drop-down the old node that you previously removed.
10. Click Delete .
NOTE : This node is no longer in the network and deleting it will help avoid confusion.
Enable and connect remaining nodes to the Enterprise Controller
1. Select Setup : Site Settings : Network Nodes .
2. Select a node from the Name drop-down.
3. Click the Enabled box and make any needed changes to the node’s settings.
4. Click Save .
5. Repeat steps 2, 3, and 4 for each node in the system.
6. Select Setup : Site Settings : Network Controller .
7. Check that the nodes are now connected to the Enterprise controller. Each node should
appear in green with the word Connected .