XX150-06-00 Rev 1010 Roughneck V926 Fixed-Position Camera Dome Installation
•
5
Figure 3
Camera Connections
6. Connect the video cable male BNC to the female pendant cable BNC video connector from the PC board.
Note: After mating the male/female BNC connectors, it is recommended that these connections be wrapped
with electrical tape to prevent shorts.
ALTERNATE CONNECTIONS:
For the model using the twisted-pair video connection, connect the
twisted pair module provided to the BNC connector; then connect the twisted-pair video wires to the
module. Strip off approximately 0.25 in. (6 mm) of insulation from each individual wire. Attach each wire to
the screw terminal on the module. This signal is polarized and specific wire connection is necessary.
Follow the markings on the board for connections. Refer to the instructions supplied with the receiver for
those connections.
Summary of Contents for Roughneck V926-C26
Page 2: ......
